98天津某广场机电安装工程施工组织设计.doc
第1章 工程概述 2
第1节 工程简介 3
第2节 工程工期 3
第3节 工程质量 3
第4节 工程有关管理单位 4
第5节 工程本次投标范围 4
第6节 工程环境条件 4
第7节 施工组织设计编制的依据 5
第2章 机电工程专业特点 5
第1节 综述 5
第2节 空调、通风及防排烟系统 6
第3节 制冷机房及锅炉房系统 7
第4节 给水及排水系统特点 8
第5节 电气系统 9
第3章 项目管理 11
第1节 计算机文档管理及应用 11
第2节 分承包方的管理 11
第3节 物资管理 12
第4节 合约管理 15
第5节 机电安装项目管理机构设置 17
第6节 机电工程总承包管理模式 32
第7节 项目管理目标 33
第4章 施工部署及配套计划 33
第1节 施工部署 33
1、 施工流水段的划分及部署原则 33
2、 机电各专业的施工部署 34
第2节 施工进度计划 44
1、 工程总控计划 44
2、 工程进度控制计划 46
第3节 工期保证措施 47
第4节 施工主要机具及检测设备计划 48
第5节 劳动力计划安排 52
第6节 主要设备及材料供货计划 54
第5章 施工准备工作 81
第1节 人力资源的组织准备 81
第2节 物质准备 81
第3节 现场临时设施 82
第4节 技术准备工作 83
第5节 施工详图的二次设计 84
第6章 主要施工方法与技术措施 84
第1节 通风、空调系统 84
1、 空调水管道安装 84
2、 通风管道制作安装 92
3、 通风空调、制冷机房及锅炉房设备安装 96
4、 消声与隔震 100
5、 风管系统的透光法检查及漏风量测试 104
6、 冲洗与试压 105
7、 防腐与保温 106
8、 试运转及系统调试 109
第2节 给排水系统安装 115
1、 排水用PVC-U管道的安装 115
2、 铸铁管安装 119
3、 焊接钢管安装 119
4、 污水泵安装 120
5、 试验要求 120
6、 管道保温及防腐 121
第3节 设备吊装运输方案 122
1、 本工程大型设备 122
2、 室内楼层间的垂直运输,可以采用以下方法: 123
3、 地上各设备层中 125
4、 安全注意事项 125
第4节 电气系统安装 126
1、 施工做法 126
2、 安装配合阶段 136
3、 关键工序节点做法 144
第7章 推荐本工程中使用的新工艺 147
第1节 组合法兰风管制作与安装工艺 147
1、 材质要求 147
2、 加工工艺流程 147
第2节 工艺管道支吊架标准化技术 150
第8章 施工中执行的规程、规范、标准图集 152
第1节 空调、采暖及通风系统 152
1、 GBJ19-87 152
2、 GBJ242-82 152
3、 GB50045 152
4、 IEC 153
第2节 给排水工程 153
1、 GBJ15-88 154
2、 IEC 154
第3节 低压供电系统 154
1、 GBJ50169-92 155
2、 IEC 155
第4节 弱电系统 155
1、 IEC 156
第5节 所有中国国家及地方(天津)政府机构的有关规定 156
第1章 工程概述
Chapter 1 Project Overview 2
Section 1 Project Description 3
Section 2 Project Duration 3
Section 3 Project Quality 3
Section 4 works and the management unit 4
Section 5 of this bid scope of work 4
Section 6 of the project environment 4
Section 7 of the basis for the preparation of construction organization design 5
Chapter 2 Characteristics of the Electrical and Mechanical Engineering 5
Section 1 Overview 5
Section 2 air-conditioning, ventilation and smoke control system 6
Section 3 Refrigeration System 7 machine room and boiler room
Section 4 of 8 water supply and drainage system characteristics
Section 5 Electrical Systems 9
11 Chapter 3 Project Management
Section 1 of Document Management and Computer Application 11
Section 2 of 11 sub-contractor management
Section 3 Materials Management 12
Contract Management Section 4 of 15
Section 5 Electrical installation project management for 17
Section 6 Contract Management Electrical and Mechanical Engineering 32
Section 7 of 33 project management objectives
Chapter 4 and associated construction plans to deploy 33
Construction of section 1 of the deployment of 33
1, the construction and deployment of the division of water principle in paragraph 33
2, mechanical and electrical construction of the deployment of 34 different professions
Section 2 44 Construction Schedule
1, general control scheme 44
2, the progress control program 46
Section 3 schedule assurance measures 47
Section 4 of the major construction machinery and testing equipment program 48
Section 5 of the 52 labor scheduling
Section 6 of the main equipment and materials supply plan 54
Chapter 5 81 construction preparation work
Section 1 The organization of human resources to prepare 81
Section 2 of material to prepare 81
Section 3 of 82 temporary facilities on site
Technical preparation for Section 4 of 83
Section 5 of the 84 construction detail drawing of the second design
Chapter 6 Construction Methods and Techniques 84
Section 1 ventilation and air conditioning system 84
1, air-conditioning installation of 84 water pipe
2, ventilation pipe manufacture and installation of 92
3, ventilation and air conditioning, plant room and boiler room equipment installation 96
4, noise elimination and isolation 100
5, air duct system, light transmittance and air leakage test 104 checks
6, rinse and Pressure Test 105
7, anti-corrosion and insulation 106
8, commissioning and system debugging 109
Section 2 to the drainage system installation 115
1, PVC-U drainage pipe installation 115
2, cast iron pipe installation 119
3, welded steel pipe installation 119
4, 120 sewage pump installation
5, 120 test requirements
6, pipe insulation and anti-corrosion 121
Section 3 of 122 equipment lifting transport program
1, the construction of 122 large-scale equipment
2, indoor vertical transportation between floors, you can use the following method: 123
3, the ground layer of the device 125
4, 125 security considerations
Section 4 Electric System Installation 126
1, construction practices 126
2, the installation with the stage 136
3, the key process node approach 144
Chapter 7 recommend the use of new technology project 147
Section 1 combination flange duct manufacture and installation process 147
1, material requirements 147
2, processing flow 147
Section 2 technology supports and hangers Standardization 150
Chapter 8 Construction of the implementation of the rules, norms, standards Atlas 152
Section 1 air-conditioning, heating and ventilation systems 152
1, GBJ19-87 152
2, GBJ242-82 152
3, GB50045 152
4, IEC 153
Section 2 Drainage Project 153
1, GBJ15-88 154
2, IEC 154
Section 3 of 154 low-voltage power supply system
1, GBJ50169-92 155
2, IEC 155
155 Section 4 Weak system
1, IEC 156
Section 5 of all the Chinese national and local (Tianjin) the relevant provisions of 156 government agencies
Chapter 1 Project Overview
帮助中心 收藏 >>> |
本类栏目导航
总点击排行
- 天正建筑2013最新64位破解版
- 173549次
- Autocad2013 64位32位破解版附带注册机
- 154873次
- 天正建筑8.5破解版
- 146385次
- autocad2012 64位32位 破解版(附注册
- 139022次
- 天正建筑8.2破解版
- 127265次
- autocad2010免费下载(简体中文版)
- 98144次
- 免费农村房屋设计图
- 90906次
- CAD2008注册机及使用说明
- 84341次
- 11g101图集全套下载
- 78882次
- cad图集大全
- 67445次
- 天正电气8.5破解版
- 18395次
- 防雷引下线做法
- 2002次
- 国家标准图集-电气图例(CAD)
- 1320次
- 10kV及以下架空配电线路设计技术规程
- 1080次
- 山西***110kv输电线路施工组织设计(含
- 1074次
- 电气制图和识图知识
- 1020次
- 外电防护方案
- 1007次
- 铜芯电线电缆载流量标准IEC60364-5-523
- 944次
- 电梯安装施工方案
- 812次
- 线路敷设方式代号对照
- 775次