普通灯具安装工艺标准.doc

普通灯具安装工艺标准
    总则、术语符号及基本规定参见5不间断电源安装。
    11．1  施工准备
    11．1．1  技术准备
    (1) 施工前应进行技术交底工作；
    (2) 配备相应的施工质量验收规范。
    11．1．2  材料设备要求
    (1) 注意核对灯具的标称型号等参数是否符合要求，并应有产品合格证，普通灯具有安全认证标志。
    (2) 照明灯具使用的导线其电压等级不应低于交流500V，其最小线芯截面应符合规定。
    (3) 采用钢管作为灯具的吊管时，钢管内径一般不小于10mm。
    (4) 花灯的吊钩其圆钢直径不小于吊挂销钉的直
General lighting standard installation process
    General principles, terminology and basic provisions of symbols see 5 uninterruptible power supply installation.
    11.1 Construction preparation
    11.1.1 Technical Preparation
    (1) the classification of components should be carried out before construction work;
    (2) with the corresponding acceptance of construction quality.
    11.1.2 The material and equipment requirements
    (1) Note that the nominal model matching parameters such as lighting for compliance and should have product certification, general lighting a safety certification mark.
    (2) lighting wire the voltage levels used in exchange should not be less than 500V, the minimum wire core section shall comply with requirements.
    (3) using steel as a hanging lamp tube, steel pipe inner diameter is generally not less than 10mm.
    (4) lantern hook the round bar diameter is not less than hanging straight pin
 

前往下载