中小型机械操作工安全技术交底.doc

中小型机械操作工安全技术交底
1. 现场施工机械必须按施工平面图布置，如须移动，必须经现场施工负责人同意方可移动。
2. .现场机械安装应稳固，带有胶轮胎的机械应将轮胎拆下并垫离地面，保养好。按规定搭设操作平台、防护栏杆，保证进。出料安全，整机应搭设安全可靠的操作棚。
3. .机械安装或检修完毕，必须经试运转正常后，办理交接班签证手续后方准使用。
4. .一切机械、电器设备的金属外壳和行车轨道必须接零、接地线，电阻不大于10欧。在同一供电系统中不准有的设备接零有的设备接地。
5. .接新的用电规程JGJ46-88规定，所有的施工机械都应安装漏电保护器。特别是移动型机具，不安装漏电保护器不得使用。
6. .实行一机一闸制，所有机械都应设独立的开关箱，箱内不得存放什物。开关距所控设备水平距离不宜超过3m。
7. .机械操作人员要事先经过培训，三机操作工要持证上岗。严禁违章作业，严格执行操作规程，实行定机定人定责任制。
8. .操作工应做到“四懂”“三会”即，懂构造、原理、性能、用途、会操作、会维修保养、会排除故障。
9. .工作前必须按规定穿戴好防护用品，操作旋转机库严禁戴手套。女工要戴女工帽，长发不得外露。
.使用移动型机具，操作人员应严格执行穿绝缘鞋戴绝缘手套的规
Small Plant Operator Safety Technology Details
1. The scene of construction machinery and construction plan must be arranged as to be mobile, construction-site person in charge must be agreed before move.
2.. On-site mechanical installation should be firm, with mechanical rubber tires and mats should be removed from the ground tires, maintenance good. Erection of platforms required, protective railings, to ensure progress. The material security, the whole erection of safe and reliable operation should be shed.
3.. Mechanical installation or maintenance is completed, must be approved by the normal test run, the process behind the potential use of shift change visa.
4.. All the machinery, electrical equipment, metal case and driving tracks to take zero, grounding wire, the resistance is not more than 10 euro. In the same power supply system, some devices are not allowed to take some equipment ground zero.
5.. Then the new electricity regulations JGJ46-88, all of the construction machinery should be installed with leakage protector. Particular type of mobile equipment, earth leakage protection devices are not prohibited.
6.. A gate to implement a machine system, all machinery should be set up independent switch box, box may not be kept odds and ends. Switch horizontal distance from the control equipment should not exceed 3m.
7.. Machine operators to pre-trained, three machine operators to be certified. Prohibited illegal operation, strict operational rules, is scheduled to implement the responsibility system man-machine set.
8.. Operatives should be "four to understand" the "three will" that is, knowledge of the structure, principle, performance, use, operate, repair and maintenance will be troubleshooting.
9.. The work of the former must wear good protective equipment required to operate rotating hangar forbidden to wear gloves. Female workers to wear hats, long hair and not exposed.
. Using a mobile-type equipment, operating personnel should strictly enforce the wearing insulated gloves wearing regulation shoes