钢木门窗安装工程安全作业交底.doc

内容摘要：
1、 进入施工现场人人都必须遵守信达建筑工程公司的各项规章制度和纪律。
2、 操作者应经常检查所用工具是否牢固，防止脱柄伤人。
3、 安装上层窗扇时不要向下乱扔东西，工作时注意脚要踩稳，不要向下看。
4、 搬运钢门窗时应轻放，不得使用木料穿入框内吊运至操作位置。
5、 钢门窗不得平放，应该竖立，其竖立坡度不大于20度，并不准人字型堆放。
6、 不准脚踩窗扇芯子，或在窗扇芯子放置脚手板和悬吊重物。
7、 使用木工机械，禁止戴手套，操作时必须集中思想，认真操作，不得与他人谈笑。
8、 锯刨木料时推进速度不能太快，本节应放在推进方向的前面；不能刨过短木料及过薄小条子等材料。
9、 木工机械的基座必须稳固，部件必须齐全，机械的转动和危险部位必须按规定安装防护装置。
10、不准任意换粗保险丝，特别对机械的刀盘部分要严格检查，刀盘螺丝必须旋紧，以防刀片飞出伤人。
11、木料机械必须有专人负责，操作人员必须熟悉该机械性能，熟悉操作技术做到持证上岗。
12、严禁机械无人负责或随便动用，木工机械使用必须实施二级漏电保护，用完时应切断电源并将开关箱关门上锁。
13、木工车间、木库、木料堆场严
Abstract:
1, into the construction site that everyone must abide by the letter of the rules and regulations up to construction companies and discipline.
2, the operator should always check whether the firm used tools, to prevent the removal handle wounding.
3 Do not install the upper sash down to throw things at work to pay attention to step foot stability, not to look down.
4, removal of steel doors and windows should be light up, can not penetrate the wood box used to operate the lifting position.
5, steel doors and windows can not flat, it should be erected, the erection is not greater than 20 degrees slope, and ban the font stack.
6 foot window sash closed cores, or cores placed in the window sash suspended scaffold boards and heavy.
7, the use of woodworking machinery, banned from wearing gloves, the operation must focus on thought, serious action, not talk and laugh with others.
8, saw the advancing speed when planing wood can not be too fast, this section should be placed in front of the advancing direction; can not dig too short and too thin small strips of wood and other materials.
9, the base must be solid woodworking machinery, parts must be complete rotation and dangerous parts of machinery must be installed in accordance with the provisions of protection devices.
10, not allowed to arbitrarily change crude fuse, in particular, part of the machinery necessary to strictly inspect the cutter, cutter screw must be tightened to prevent the blade flying out of wounding.
11, wood machinery must be responsible, the operator must be familiar with the mechanical properties, be familiar with the operation of technical certificates.
12, no one is responsible for non-mechanical or casual use, woodworking machinery used to implement two leakage protection, used to cut off power and switch boxes should be locked shut.
13, a carpentry workshop, wood library, timber yard Yan