机电设备安全技术规程岩土.doc

1、机械操作，要束紧袖口，女工发辫要挽入帽内。
2、机械和动力机的机座必须稳固。转动的危险部位要安设防护装置。
3、工作前必须检查机械、仪表、工具等，确认完好方准使用。
4、电气设备和线路必须绝缘良好，电线不得与金属物绑在一起；各种电动机具必须按规定接零接地，并设
置单一开关；遇有临时停电或停工休息时，必须拉闸加锁。
5、施工机械和电气设备不得带病运转和超负荷作业。发现不正常情况应停机检查，不得在运转中修理。
6、电气、仪表、管道和设备试运转，应严格按照单项安全技术措施进行。运转时不准擦洗和修理，严禁将
头手伸入机械行程范围内。
7、在架空输电线路下面工作应停电。不能停电时，应有隔离防护措施。起重机不得在架空输电线路下面工
作，通过架空输电线路时应将起重臂落下。在架空输电线路一侧工作时，不论在任何情况下，起重臂、钢丝
绳或重物等与架空输电线路的最近距离不小于下表规定：
输电线路电压 l千伏以下、 1－20千伏、 35－110千伏 154千
1, machine operation, to tighten cuff, women in braids to pull into the cap.
2, mechanical and power machine of the base must be solid. The risk of rotating parts to install protective devices.
3, before work to check the machinery, instruments, tools, etc., are allowed to be used to confirm intact.
4, electrical equipment and wiring must be insulated well and not with the metal wires tied together; all kinds of motors required to be connected with ground zero, and let
Purchase a single switch; the event of power outages or downtime to rest, to wind up its lock.
5, construction machinery and electrical equipment operation and overload operation may not sick. Found to be not normally be down to check, not in operation in the repair.
6, electrical, instrumentation, piping and equipment commissioning, should be strictly in accordance with individual security technology measures. Running are not allowed to wash and repair, is strictly prohibited
First hand into mechanical travel range.
7, the overhead transmission lines should be the following power cuts. Can not be a power failure, protective measures should be isolated. Crane shall not work below overhead transmission lines
For, by overhead transmission lines should be boom down. Overhead transmission line side of the work, whether in any case, the boom, steel wire
Rope or heavy objects such as overhead transmission lines with not less than the minimum distance requirements in the following table:
L kV transmission line voltage is below the 1-20 kV, 35-110 kV 154 1000