综合布线系统安装技术交底-北京建工集团.doc

 1  范围
    本工艺标准适用于建筑物内楼宇自动化控制用综合布线系统安装丁程。
    2  施工准备
    2.1  材料要求：
    2.1.1  对绞电缆和光缆型号规格、程式、形式应符合设计的规定和购销合同的规定。电缆所附标志、标签内容应齐全、清晰。电缆外护套须完整无损，电缆应附有出厂质量检验合格证，并应附有本批量电缆的性能检验报告（注：电缆标志内容：在电缆的护套上约以lm的间隔标明生产厂厂名或代号及电缆型号规格，必要时还标明生产年份。标签内容：电缆型号规格，生产厂厂名或专用标志，制造年份、电缆长度）。
    2.1.2  钢管（或电线管）型号规格，应符合设计要求，壁厚均匀，焊缝均匀，无劈裂，砂眼，棱刺和凹扁现象。除镀锌管外其它管材需预先除锈刷防腐漆（现浇混凝土内敷钢管，可不刷防腐漆，但应除锈）。镀锌管或刷过防腐漆的钢管外表完整无剥落现象，并有产品合格证。
    2.1.3  管道采用水泥管块时，应符合邮电部《通信管道工程施工及验收技术规范》（YDJ39一90）中相关规定。
1 Scope
    This technology is applicable to buildings with building automation control integrated wiring system installation Ding Cheng.
    2 construction preparation
    2.1 Material Requirements:
    2.1.1 twisted pair cable and fiber type specification, programming, form design should be consistent with the provisions and purchase and sale contract. Cable attached to signs, labels should be complete and clear. Cable sheath to be intact, the cable should be accompanied by factory quality inspection certificate and shall be accompanied by the bulk properties of the cable test report (Note: the content of cable signs: the jacket on the cable about to plant lm intervals marked the make or model code and cable specifications, if necessary, indicate the year of manufacture. labels: cable model specifications, the product, name or special symbol, the year of production, cable length).
    2.1.2 pipe (or wire tube) model specification should be consistent with design requirements, wall thickness, weld uniformity, no splitting, trachoma, stabbed and concave edge flat phenomenon. In addition to other pipe galvanized pipe outside the required pre-rust anti-corrosion paint brush (cast steel in concrete deposited, from time to anti-corrosion paint brush, but it should be rust). Galvanized pipe or steel pipe anticorrosive paint brush over surface integrity of peeling, and a product certification.
    2.1.3 Pipeline blocks using cement pipe shall conform to the Ministry of Posts and Telecommunications "communications pipeline construction and acceptance of technical specifications" (YDJ39 a 90) in the relevant regulations.