9-38 裱糊工程施工工艺标准（938-1996）
1 范围
本工艺标准适用于工业与民用建筑的内墙面、顶棚等的裱糊工程
2 施工准备
2.1 材料要求：
2.1.1 石膏、大白、滑石粉、聚醋酸乙烯乳液、羧甲基纤维素、107胶或各种型号的壁纸、胶粘剂等。
2.1.2 壁纸：为保证裱糊质量，各种壁纸、墙布的质量应符合设计要求和相应的国家标准。
2.1.3 胶粘剂、嵌缝腻子、玻璃网格布等，应根据设计和基层的实际需要提前备齐。但胶粘剂应满足建筑物的防火要求，避免在高温下因胶粘剂失去粘结力使壁纸脱落而引起火灾。
2.2 主要机具；
2.2.1 裁纸工作台、钢板尺（1m长）、壁纸刀、毛巾、塑料水桶、塑料脸盆、油工到板、拌腻子槽、小辊、开刀、毛刷、排笔、擦布成棉丝、粉线包、小白线、铁制水平尺、托线板、线坠、盒尺、钉子、锤子、红铅笔、砂纸。笤帚、工具袋等。
2.3 作业条件：
2.3.1 混凝土和墙面抹灰已完成，且经过干燥，含水率不高于8%；木材制品
9-38 paper the construction technology standards (938-1996)
1 Scope
This process is applicable within the walls of industrial and civil buildings, such as wall paper roof project
2 construction preparation
2.1 Material Requirements:
2.1.1 Gypsum, hidden, talc, polyvinyl acetate emulsion, carboxymethyl cellulose, 107, or various types of wallpaper glue, adhesive, etc..
2.1.2 Wallpaper: To ensure the quality of wall paper, all kinds of wallpaper, wall fabric quality should meet the design requirements and the corresponding national standards.
2.1.3 adhesives, caulking putty, glass mesh cloth, etc., should be based on the actual design and grassroots get ready in advance. But the adhesive shall meet the building's fire safety requirements, to avoid high temperature due to loss of bond strength to adhesive wallpaper off and cause a fire.
2.2 Main equipment;
2.2.1 trimmer table, plate-foot (1m long), wallpaper knife, towel, plastic bucket, plastic basin, the oil workers to the plate, mixed with putty groove, small roll, knife, brush, brush, rags, into cotton yarn, pink line package, white line, iron spirit level, care line board, the line sinkers, box feet, nails, hammers, red pencil, sandpaper. Broom, tool bags.
2.3 Operating conditions:
2.3.1 Concrete and plaster walls have been completed, and after drying, the moisture content no higher than 8%; wood products