塑料（塑胶）面层施工工艺标准
9．21．3基本规定
（1）塑料板面应采用塑料板块材、塑料板焊接、塑料卷材以上胶粘剂在水泥类基层上铺设。
（2）水泥类基层表面应平整、坚硬、干燥、密实、洁净、无油脂及其他杂质，不得有麻面、起砂裂缝等缺陷。
（3）胶粘剂选用应符合现行国家标准《民用建筑工程室内环境污染控制规范》GB50325-2001的规定。其产品应按基层材料和面层材料使用的相容性要求，通过试验确定。
（4）塑料板面层的允许偏差应符合国家标准《建筑地面工程施工质量验收规范》GB50209-2002中表6.1.8的规定。
（5）应遵守9.1.3和9.1.6的有关的规定。
9.21.4  施工准备
Plastic (plastic) surface construction technology standards
9.21.3 Basic requirements
(1) The board of plastic materials to be used plastic plates, plastic sheet welding, adhesive plastic sheet over the laying of the concrete class of grass-roots level.
(2) Cement primary surface should be smooth, hard, dry, dense, clean, no grease and other impurities, may not have pockmarked face, from the sand cracks and other defects.
(3) The adhesive used should be consistent with current national standard "civil engineering indoor environmental pollution control" GB50325-2001 requirements. Basic materials and their products should be used in surface material compatibility requirements, determined through experiments.
(4) The surface layer of plastic sheet to allow deviation should be consistent with national standards "of Ground Engineering Construction Quality Acceptance" GB50209-2002 the provisions of Table 6.1.8.
(5) shall comply with 9.1.3 and 9.1.6 of the relevant requirements.
9.21.4 Construction preparation