木丝吸音板安装方法_secret.doc

一、安装施工
1、 墙面的安装
①木龙骨在有木龙骨的情况下，从木丝板的侧面即15-25mm厚处斜角钉入普通大铁钉在
　　　 木龙骨上，板材的正面射枪钉在木龙骨上即可。
备注：木龙骨上要涮防火涂料，以确保全面防火的效果。
　　 ②轻钢龙骨 在层高较高或防火要求等级较高时，可能不允许使用木龙骨，施工时可
　　　 以用自攻螺丝把小段的木垫片固定在轻钢龙骨上，然后把吸音板固定在木片上，
　　　 具体施工方法同上①，如果直接安装在轻钢龙骨上就需要使用自攻螺钉固定。
　　 ③如果没有龙骨直接安装在墙面时，可以使用强力胶直接粘贴，在可能的情况下，
　　　 表面散射枪钉。木基材可以使用白胶加枪钉 。
2、 吊顶的安装
     ①普通明架、半明架龙骨的安装方式同矿棉板，龙骨的选择应当注意板材尺寸(一般为
       600×600mm或600×1200mm)与之相配合，吊筋比普通矿棉板的龙骨稍微密一点。
　　 ②顶部为木龙骨的安装方式同墙
1, Installation
1, the installation of wall
① wooden keel keel in a wooden case, wood wool board from the side of the angle 15-25mm thick at large nails driven into in the ordinary
Wooden keel on the front panel a gun can be nailed on the wooden keel.
Note: wood keel on fire coating to rinse, to ensure the full effect of fire.
②-storey high metal frame or the fire safety requirements in the higher grades, may not allow the use of wood keel, the construction can be
To use self-tapping screws to short sections of wooden spacer to light steel keel, and then fixed in the wood chips on the sound-absorbing panels,
Concrete construction method Ibid ①, if installed directly on the metal frame on the need to use self-tapping screws.
③ If there is no keel installed directly on the wall, you can use glue directly paste, where possible,
Surface scattering nail gun. You can use white glue wood substrate plus nail gun.
2, the installation of ceiling
     ① General Ming frame, half way out the installation of the keel frame with mineral wool board, keel should be noted that the choice of plate size (usually
       600 × 600mm or 600 × 1200mm) with match, hanging bars than the average density mineral wool board keel a little bit.
② top of the keel for the installation of wood with the wall