内容摘要：
1、 进入施工现场必须遵守安全生产的各项规章制度和纪律等。
2、 钢筋断料、配料、弯料等工作应在地面进行，不准在高空操作。
3、 搬运钢筋要注意附近有无障碍物、架空电线和其它临时电气设备，防止钢筋在回转时碰撞电线或发生触电事故。
4、 现场绑扎悬空大梁钢筋时，不得站在模板上操作，必须在脚手板上操作。
5、 绑扎3m以上独立柱钢筋时，必须搭设操作平台。
6、 不准站或坐在柱箍筋上绑扎，也不准将木料、管子、钢模板穿插在钢箍上作立人板。
7、 起吊钢筋骨架，下方禁止站人，必须待骨架降到距模板1m以下才准靠近，就位支撑好后方可摘钩。
8、 起吊钢筋时，规格必须统一，不准长短参差不一，细长钢筋不准一点吊。
9、 切割机使用前，须检查机械运转是否正常，有否二级漏电保护；切割机后方不准堆放易燃物品。
10、钢筋头子应及时清理，成品堆放应整齐，工作台要稳，钢筋工作棚照明灯必须加网罩。
11、高空作业时，不得将钢筋集中堆在
Abstract:
1, into the construction site must comply with safety rules and regulations and discipline.
2, steel cutting, ingredients, materials, etc. should be bent on the ground were not allowed to operate at high altitude.
3, moving near the bar to pay attention to whether the barrier, temporary overhead lines and other electrical equipment to prevent the steel wires in the rotation when the collision occurred or electric shock.
4, left vacant spot beam steel banding shall not stand in the template to operate, must operate in the scaffold board.
5, 3m or more independent column steel banding must be erection platform.
6, allowed to stand or sit on the Binding column stirrup, or brigadier general timber, pipe, steel template inserted a steel hoop to make Liren board.
7, lifting steel frame, below the ban stand, must be dropped from the skeleton template 1m the following before they close, good support in place only after uncoupling.
8, lifting bar, the specifications must be unified, not allowed to vary in length, slender steel are not allowed to hang a little.
9, cutting machine before use, to check the machine is functioning properly, it has two leakage protection; cutting machine behind the combustible materials are not allowed to pile up.
10, reinforced head should be cleared up, finished products should be neatly stacked, tables should be stable, reinforced the work of studio lighting to increase the guard.
11, high-altitude operations, shall focus on the heap will be reinforced in