土方开挖压路机操作人员安全技术交底.doc

交底内容：
1．作业前，检查各系统管理及接头部分应无裂缝、松动和泄露现象，各紧固螺丝无松动，确认正常后方可启动。
2．变压路机前进、后退方向，应待滚轮停止滚动后进行，严禁利用换向离合器做制动用。
   3．起振必须在压路机行走后进行，停振必须在压路机停车前进行，压松散路基时，应先在不振情况下压1~2遍，再用振动压实。 
   4． 作业后压路机应停放在坚实、平坦、安全的地方。
Cards on the table contents:
1. Work, check some of the systems management and joints should be no cracks, loose and leak phenomenon, no loosening the fastening screws, confirmed only after the normal start.
2. Variable roller forward and backward direction, wait until after the wheel stops rolling, non-use change do to the clutch brake.
   3. Walk from vibrating roller to be after, stop vibration to stop before the roller, pressure loose subgrade should be the first case in the weak pressure of 1 to 2 times, then vibration compaction.
   4. After the roller operation should be parked in a solid, flat, safe place.