广州南沙开发区黄阁东路工程气焊工操作安全技术交底.doc

1、气焊工须持特种作业证上岗，作业证过期未年审的不准施焊作业。
2、施焊作业必须办理动火审批手续。
3、施焊场地周围应清除易燃易爆物品,或进行覆盖、隔离，并在施焊部位配备灭火器材。
4、必须在易燃易爆气体或液体扩散区施焊时，应经有关部门检试许可后，方可施焊。
5、乙炔气瓶必须装减压阀和防回火装置，乙炔气瓶和氧气瓶之间距离不得小于5m，严禁平放，严禁曝晒，距易燃易爆物品和明火的距离不得少于10 m。检验是否漏气，要用肥皂水，严禁用明火。
6、氧气瓶、氧气表及焊割工具上，严禁沾染油脂。
7、气瓶的购、运、储存和领用必须严格执行公安部门的有关规定。
8、点火时，焊枪口不准对人，正在燃烧的焊枪不得放在工件或地面上。带有乙炔和氧气时，不准放在金属容器内，以防气体逸出发生燃烧事故。
9、严禁在带压力的容器或管道上施焊，焊接带电的设备必须先切断电源。
10、焊接贮存过易燃、易爆、有毒物品的容器或管
1, gas welder must hold a special work permit for employment, work permits are not allowed overdue annual examination of the weld operation.
2, Shih welding operations must apply for approval of hot work procedures.
3, the weld should be clear space around the inflammable and explosive materials, or cover, isolation, and in the weld area is equipped with fire fighting equipment.
4, flammable gas or liquid to be spread in the weld area should be seized by the relevant trial license only after the welding operation.
5, acetylene cylinder valve must be installed and anti-tempering equipment, acetylene cylinders and oxygen cylinders shall not be less than the distance between the 5m, is strictly prohibited flat, non-exposure, and open flame away from flammable substances shall not be less than the distance 10 m. Test whether the leak, use soapy water, open flame is strictly prohibited.
6, oxygen bottles, oxygen forms and welding tools, oil contamination is strictly prohibited.
7, cylinders of purchase, transport, storage and requisitioned to strictly enforce the relevant provisions of the public security department.
8, ignition, the torch exit are not allowed on the people, shall not be placed on the burning torch on the workpiece or ground. With acetylene and oxygen, are not allowed on the metal containers to prevent escape of gas burning accident occurred.
9, is prohibited with the pressure applied on the container or pipe welding, welding equipment must be cut off electric power.
10, welding store had flammable, explosive, toxic substances in the container or pipe