滑升模板安装工程安全作业交底.doc

内容摘要：
1、 滑模平台在提升前应对全部设备装置进行检查，调试妥善后方可使用，重点放在检查平台的装配、节点，电气及液压系统。
2、 平台内，外吊脚手架使用前，应一律安装好轻质牢固的小眼安全网，并将安全网从外吊脚手架底部包到紧靠筒壁的吊脚手架里栏杆上，经验收合格后方可使用。
3、 为了防止高空物体坠落伤人，筒身内底部，一般在2.5m高处搭设双层保护棚，双层间距不得小于600mm，并一上部宜铺一层6-8mm钢板防护，或5cm厚木板。
4、 避雷设备应有接地线装置，平台上振动器\电机等应接地或接零。
5、 通信设备除电铃和信号灯外，还应装备3-4台步话机。
6、 滑升模板在施工前，技术部门必须做好切实可行的施工方案及流移示意，操作人员必须严格遵照执行。
7、 滑模在提升时必须统一指挥，并有专人负责测量千斤顶，平台应保持水平，升高时出现不正常情况时，应立即停止滑升，再找出原因，并制定相应措施后方准继续滑升。
8、 滑模施工设计时，必须注意施工过程中结构的稳定和安全。
9、 滑模施工工程操作人员的上下，应设置可靠楼梯或在建筑物内及时安装楼梯。
10、用降模法施工现浇楼板时，各吊点应加设保险钢丝绳。
11、滑模施工中，应严格按施工组织设计要求分散堆载，平台不得超载且不应出现不均匀堆载的现象。
12、施工人员必须统一服从指挥，不得擅自操作液压设备和机械设备。
13、滑模施工场地必须有足够的照明，操作平台上的照明采用36V的安全电压。
14、凡患有高血压、心脏病及医生认
Abstract:
1, sliding platform to enhance the former should inspect all equipment installations, commissioning properly before use, focusing on the inspection platform assembly, node, electrical and hydraulic systems.
2, platform, internal and external use of suspended scaffolding, should be installed with small eyes light strong safety net, safety nets and scaffolding hanging from the outside bottom of the pack to close in cylinder wall hanging scaffold railing, and passes back may be used.
3, fall injuries in order to prevent high-altitude objects, Flashlight in the bottom, usually in the erection of 2.5m high roof double protection, double spacing of not less than 600mm, and an upper layer of 6-8mm appropriate protective plate, or wood 5cm thick board.
4, lightning protection equipment should be grounded wire device, platform vibrator \ motor and so should be grounded or connected zero.
5, communications equipment than bells and lights, the station should be equipped with walkie-talkies 3-4.
6, sliding template before construction, technology departments must do a practical construction plan and the current shift indicated, the operator must be strictly followed and implemented.
7, sliding must be unity of command in the upgrade and have the person responsible measure jack, the platform should remain level, when higher abnormal situation, should immediately stop sliding, and then find out the reason behind the standards and develop appropriate measures to sliding.
8, slipform construction design, construction process must pay attention to the structure's stability and security.
9, sliding up and down the construction project operator, should be set to secure the stairs or the installation of stairs in a building in a timely manner.
10, with reduced form construction of floor slab, each lifting point should be added an insurance rope.
11, sliding construction, should be strictly required by the construction organization design distributed loading, platforms may not overloaded and should not have uneven Loading phenomenon.
12, construction workers must be unity of command and obedience are not allowed to operate hydraulic equipment and machinery.
13, sliding construction site must have adequate lighting, the lighting on the platform with 36V safe voltage.
14, who suffers from high blood pressure, heart disease and doctors believe