模板工程安全技术交底卡.doc

安全交底内容：
1、 木工安装模板应戴安全帽。
2、 使用木工机械进行模板加工时，双手要互相配合，不要猛拉；送料时手不宜进入台面，按料时手不宜超过锯口；加工短料时，应用手推棍送料。
3、 禁止利用拉杆、支撑攀登上下。
4、 模板及其支架在安装过程中，必须设置临时固定设施，严防倾覆。
5、 高处、复杂结构模板的拆除，应有专人指挥和切实的安全措施，并在下面标出作业区，严禁非操作人员进入作业区。
6、 严禁在同一垂直面上操作，拆除时应逐块拆卸，不得成片松动和撬落或拉倒；拆除平台、楼层板的底模时，应设临时支撑，防止大片模板坠落，尤其是拆柱模时，操作人员应站在门窗洞口往外拉拆，更应严防突然全部掉落伤人。
7、 严禁站在悬臂结构上面敲拆底模。
8、 拆模时应防止钉子扎伤。
9、 拆模完工前，不得留下松动和悬挂的模板，拆下的模板应及时集中堆放。
10、圆盘锯要经检查验收合格后才能使用。
Security cards on the table contents:
1, carpenter to install the template should be wearing helmets.
2, the use of woodworking machinery for template processing, the hands should complement each other, do not yank; not feed into the table when the hand by hand when the material should not exceed Jukou; processing of short materials, the application of push rod feed.
3, prohibits the use of rod, support to climb up and down.
4, templates and support during the installation process, you must set up a temporary fixed installations, prevent overturning.
5, height, removal of the template complex structure, shall be hand command and effective security measures, and marked in the following work areas, forbidden non-operators into the operation area.
6, is strictly prohibited in the same vertical plane operation, removal should be demolished block by block, not prying into pieces and drop or leave it loose; removal of platforms, the bottom floor plate model should be temporary support to prevent the large template fall, especially in demolition column mode, the operator should stand on window and door openings pull it out removed, but should prevent all falling suddenly hurt.
7, non-standing cantilevered structure above the bottom mold knock demolished.
8, form removal should be to prevent the nail stabbed.
9, form removal before completion, leaving no loose and hanging template, remove the template concentration should be stacked in time.
10, circular saw to pass through inspection and acceptance prior to use.