圆盘锯的使用安全作业交底.doc

内容摘要：
1、 操作前应检查机械是否完好，电器开关等是否良好，保险丝是否符合规格，并检查锯片是否有断和裂的现象，并装好防护罩，运转正常后方可投入使用。
2、 操作时，操作者应站在锯片左的位置，不应与锯片站在同一直线上，以防木料弹出伤人。
3、 锯片上方必须安装保险挡板和滴水装置，在锯片后面，离齿10-15cm处，安装弧形楔刀（松口刀）。
4、 送料不要用力过猛，木料拿平，不要摆动或抬高压低。
5、 料到尽头不要用手推按，以防锯片伤手指。如系两人操作下手应待木料出锯台150mm后，方可去接拉。
6、 锯短料时，必须用推杆送料。
7、 木料卡在锯片时，应立即停车后处理。
8、 如发现锯齿连续断齿达两个以上，应进行打磨减少第三齿的继续损坏。
9、 当锯片出现裂纹，长度不超过20mm，应在裂纹末端冲止裂孔。
10、严禁操作人员在酒后进入施工现场作业。
11、每个工人进入施工现场都必须头戴安全帽。
12、班组如果因劳力不足需要再招新工人时，应事先向工地报告。
Abstract:
1, the operation should be checked before the machine is intact, electrical switch is good, fuses are standard, and check the saw blade have broken and the crack phenomenon, and install a good protective cover, in normal operation only after put into use.
2, in operation, the operator should stand on the left saw the location, not with the blade on the same straight line, to prevent the wood pop wounding.
3, saw the insurance must be installed above the baffle and drip device, the saw blade back, 10-15cm away from the teeth Department, installed curved wedge knife (relenting knife).
4 Do not feed too much force, timber holding level, do not swing or raise down.
5, pushed by hand do not expect the end to prevent the blade fingers. In the case of the two operations should be lumber start with a 150mm saw Taiwan only after the pick up pull.
6, sawn material must be with his putter feed.
7, wood stuck in the blades should stop immediately after the treatment.
8, as found in serrated teeth up to two or more consecutive off, should be carried out to ascertain the continued reduction of the third tooth damage.
9, when the blade cracks, the length of not more than 20mm, the end should be washed only at the crack hole.
10, prohibited operators in the drink to the construction site work.
11, each worker entering the construction site must be wearing helmets.
12 team if the need to move because of a labor shortage of new workers, the report shall be submitted to the site.