装卸工安全作业交底.doc

内容摘要：
1、 搬运工在搬运前必须认真学习本工种操作规程中的装卸要求，并遵照执行，对零星装卸也应符合安全运输的有关规定。
2、 起重搬运各种大小设备时，必须统一规定口号、信号，统一指挥进行操作。
3、 起重搬运工具，使用前必须进行检查，不符合安全规定的不准使用。
4、 搬运机器，必须查明重量、尺寸、装卸地点后，才能操作。
5、 装运各种材料、物件时严禁超载、超高、超长、超宽。
6、 车辆未停稳，严禁人在车辆上操作或上、下爬车，物件堆放要平稳。车辆行驶时，禁止人坐在栏板上或车顶高处，更不准站在物件的顶头，防止急刹车物件往前突然移动而轧伤人，装运构件，必须选好垫头木、挂好紧线器，防止物件倒坍造成事故。
7、 密切配合驾驶员，车辆进出照顾前后，倒车、转弯、领车、正常行驶时应注意前后左右马路上的动态。
装卸乙炔、氧气瓶时应轻装轻卸，严禁抛
Abstract:
1, porters seriously studying before the removal operation rules in handling this type of work required, and follow the implementation of the sporadic loading should also be consistent with the safe transport of the requirements.
2, lifting handling equipment of all sizes, must be unified regulations slogans, signals, unified command to operate.
3, lifting handling tools must be inspected before use, do not meet safety requirements are not allowed to use.
4, handling machines, must identify the weight, size, loading and unloading sites, to operate.
5, shipping materials, objects are forbidden to overload, high, long, wide.
6, a parked vehicle is not prohibited in vehicle operation or on the crawl under the car, piled up to a smooth object. Vehicles, the prohibition of people sitting on the tailgate or roof height, but not allowed to stand in the immediate object, to prevent the brakes suddenly forward movement of objects rolling wounding, shipping component, must choose the right pad first wood, hanging good tight line device, to prevent accidents caused by objects collapsed.
7 closely with the driver, vehicle and out of care before and after the reverse, turn, lead car, the normal running around, the roads should pay attention to the dynamics.
Handling acetylene, oxygen cylinders should care, and non-throwing