模板工程安全技术交底.doc

1、按照施工方案的要求作业；
2、模板安装按施工设计进行，严禁随意变动，支顶必须有垫块；
3、上层和下层支柱在同一垂直线上，模板及其支撑系统在安装过程中，必须设置临时固定设施；
4、支柱全部安装完毕后，应及时沿横向和纵向加设水平平撑和垂直剪刀撑；
5、支柱高度小于4m时，水平撑应设上下两道，两道水平撑之间，在纵、横加设剪刀撑；
6、拆除时严格遵守安全规定，高处、复杂结构模板拆除应有专人指挥，严禁非操作人员进入作业区；
7、拆除的模板，柱杆、支撑要及时运走，妥善堆放；
8、拆除板、梁、柱墙模板，在4m以上的作业时应搭脚手架或操作平台，并设防护栏杆，严禁在同一垂直面上操作；
9、安装和拆除柱、墙、梁、板的操作层，从首层以上各层应安装安全平网。进行拆除作业时，应设置警示标牌；
10、验收合格方可进行作业，未经验收或验收不合格不准作下一道工序作业。
1, in accordance with the requirements of the construction program of work;
2, template design for installation by construction, non-random changes in the top branch must have Pad;
3, upper and lower pillar in the same vertical line, the template and the support system during the installation process, you must set up a temporary fixed installations;
4 pillars of all the installation is complete, in time along the horizontal and vertical levels of peace support and additional vertical scissors;
5, pillar height is less than 4m, the level of support should be set up and down two, two between the level of support in the vertical, wanton set scissors;
6, removal of strict compliance with safety requirements, height, remove the template complex structure should hand the command of prohibited non-operators into the work area;
7, removal of the template, pole, support should be promptly removed and properly stacked;
8, removal of panels, beams, columns wall template, operating in more than 4m should be scaffolding or platforms, and set up protective railings, non-operating in the same vertical plane;
9, installation and removal of columns, walls, beams and slabs of operation layer, from the floors above the first floor should be installed Anquan Ping network. Carrying out demolition works should be set up warning signs;
10, acceptance test to be conducted operations, without inspection, or failed the inspection are not allowed to work for the next process.